DIY Clipboard Hanger

Today, I have a project for you that is so versatile! You can use materials you probably already have on hand or can get easily. This idea is based on something I saw at Michael's that I knew I could recreate to better suit my needs. 
Are you ready to get started? 


I started with a spare 1x4 board. I cut it down to 28 inches long and sanded it smooth. If you don't have a board, you can get one cut at most home improvement stores. You can also find finished wood pieces at crafts stores that would work with this. I also used some clips that resemble clipboards. You can use regular binder clips for this as well.


Then I got started on the fun part- painting! I wanted the woodgrain to show through, so I painted a light coat of watered down acrylic paint. Then I used a cloth to rub it in. I spritzed the board with a bit of water first.

Next, I had to do a bit of math... So, my board measured 28 inches long and I wanted three clips evenly spaced. Therefore, I had the two on the ends in two inches and one in the middle that was about 12 inches from the two on the outside. Using three clips made it easy. Put the two the same distance in. Then the third one goes in the middle. I used a tape measure and pencil to mark where the clips would go.
Up until this point, I had planned to hang the board vertical.  

Now, it's time to pull out the power tools! You can absolutely use a hammer and nails if that is what you have. But who doesn't love a chance to use a drill? I drilled a hole where each of my marks were. I also made sure not to go all the way through the board. This really didn't seem to matter. However, at that point, for some reason, it mattered to me. Once your holes are drilled, use a screwdriver and small screws to attach the clips.

Lastly, I put two small nails on each side and tied a ribbon around them. This is how your cool new memo holder will hang on the wall. You could also attach a picture hanger to the back if you like it without the string. I also added a little gold paint to the heads of my screws so they matched the clips.


Now hang it on your wall and admire your handy work!